“3084 Speed Level™ Sigma Lift” Service and Parts Manual
October 2009
Page 1-4
H
Y D R A U L I C
F
L U I D
H
YDRAULIC
F
LUID
H
A N D L I N G
P
R E C A U T I O N S
PERSONS IN REGULAR CONTACT WITH MINERAL-BASED HYDRAULIC
FLUID NEED TO BE AWARE OF THE IMPORTANCE OF THOROUGH
HYGIENE AND THE PROPER METHODS FOR HANDLING MINERAL OILS,
IN ORDER TO AVOID POTENTIAL HAZARDS TO HEALTH.
IF MINERAL-BASED HYDRAULIC FLUID IS SPLASHED INTO THE EYES,
IT MUST BE WASHED OUT THOROUGHLY USING ABUNDANT
QUANTITIES OF WATER. SEEK MEDICAL ATTENTION IF IRRITATION
PERSISTS.
HYDRAULIC FLUID UNDER PRESSURE CAN PENETRATE AND BURN
SKIN, DAMAGE EYES, AND MAY CAUSE SERIOUS INJURY OR
BLINDNESS.
FLUID LEAKS UNDER PRESSURE MAY NOT ALWAYS BE VISIBLE.
F
L U I D
R
E C O M M E N D A T I O N S
MEC recommends the use of Mobile Fluid DTE 10, DTE 13 M or AW32 hydraulic fluid.
Do not substitute with lower grade fluids as pump damage may result.
S
Y S T E M
F
L U S H I N G
P
R O C E D U R E
1. With platform fully down, drain hydraulic fluid from hydraulic reservoir into a clean,
empty container.
2. When the hydraulic reservoir is empty, remove suction strainer and hoses.
3. Remove the bypass filter and hose.
4. Flush the hoses with clean hydraulic fluid.
5. Discard old bypass filter element and replace.
6. Flush out the reservoir with hoses removed from the hydraulic reservoir.
7. Reinstall all hoses removed in the previous steps.
8. Fill hydraulic reservoir with filtered, fresh hydraulic fluid (refer to Lubrication Chart).
9. Loosen output hose fittings at pump to flood with hydraulic fluid. Tighten fittings.
10. Start up the machine. Briefly operate all functions. Two or three lift cycles may be
necessary to purge all air from lift cylinder(s).
11. When the above procedures have been completed, fill hydraulic reservoir to full mark
on sight gauge.
12. Check all leaks and correct as necessary. Machine is now ready to be placed back in
operation.
NOTE:
Avoid mixing petroleum and synthetic base fluids. It is not advisable to mix fluids of different brands or types,
except as recommended.
Содержание Speed Level 2684 ES
Страница 52: ...3084 Speed Level Sigma Lift Service and Parts Manual October 2009 Page 1 32 GENERATOR OPTION 3084RT NOTES...
Страница 104: ...3084 Speed Level Sigma Lift Service and Parts Manual November 2009 Page 3 20 ENGINE MAINTENANCE NOTES...
Страница 142: ...3084 Speed Level Sigma Lift Service and Parts Manual November 2009 Page 4a 38 TROUBLESHOOTING 3084RT MODELS NOTES...
