Mec Speed Level 2684 ES, Руководство по обслуживанию и запасным частям

Страница: 76 / 206

“3084 Speed Level™ Sigma Lift” Service and Parts Manual November 2009
Page 2-24
G P 4 0 0 C
O N T R O L
M
O D U L E
S
E T U P
CE Height Calibration
For this procedure it is not necessary to place any load in the platform.
1. Drive machine to a flat, level surface where it can reach full elevation.
2. Turn selector switch to Base controls.
3. Plug EZ-Cal into connector P9 on GP400 Control Module.
• Display reads HELP: PRESS ENTER
4. Press right arrow to ACCESS LEVEL 3. Press Enter.
• Display reads CODE 0000
5. Press Up and Right Arrow to enter code 2222. Press Enter.
• Display reads ACCESS LEVEL 2.
• On later models, the display may continue to read “ACCESS LEVEL 3”. Repeat step b. and
enter code 1775.
6. Press Right Arrow to SETUPS. Press Enter.
• Display reads CHANGE DEFAULTS
7. Press Right Arrow to HEIGHT SETUPS. Press Enter.
• Display reads CALIBRATE HEIGHT
8. Press Enter.
• Display reads PLATFORM DOWN?
9. Verify that platform is fully lowered. Press Enter.
• Display reads PLEASE LIFT.
10. Hold lower controls switch in the up position until machine is fully elevated, then
release switch.
• Display reads PLEASE LOWER.
11. Hold switch in down position until platform is in the fully lowered position. Release
switch.
• Display reads FINISHED.