McHale
Fusion Vario
Baler & Wrapper
61
To drain and add oil to the gearbox, carry out the following procedure:
WARNING: Ensure the tractor is shut down before changing oil
Ensure that the tractor engine has been shut down, the key has been
removed from the ignition and the brakes have been applied before
changing oil. The PTO shaft should also be removed.
NOTE: Oil must be drained & filled after the first 5 hours of use
After the first 5 hours of use, the gearbox oil must be completely drained
and filled with SAE 80W/90 grade oil.
ENVIRONMENT: Safe disposal of oil
Respect the environment! Never spill oil or grease on the ground, never
pour them down the drain and never discard them where they can pollute
the environment. Always take waste materials to a recycling centre.
1.
Remove the filler plug (A), followed by drain
plug (B), using an 8 mm Allen key and drain oil
into a suitable container. This is best carried out
while the oil is still warm, i.e. soon after use.
Replace the drain plug (B), tighten securely and
dispose of waste oil responsibly.
2.
Remove the level plug (C) and add between 2
and 2.2 litres of SAE 80W/90 grade oil, or until
oil begins to seep out at C.
3.
Replace the level plug (C) followed by filler plug
(A) and tighten securely.
After this, replace the oil once per season or once
per 10,000 bales, whichever comes first.
NOTE: Do not overfill the oil
Do not overfill the oil, as this will result in overheating and oil leakage.
A
C
B
1
