McHale 900340, Инструкция оператора

Страница: 50 / 155

McHale Fusion Vario Baler & Wrapper
50
After the roll is replaced, the tractor and electronic control box is powered back up and
the PTO is engaged. Once the net button is pushed, the net feeds into the chamber,
netting the bale and the knife trips. The operator then checks that netting is complete
and work can continue as normal.
6.5 Net layer adjustment setting
In an automatic cycle, the netter starts feeding net once the set bale diameter has been
reached. After a number of pulses have occurred the net feed arm is released, the net
is introduced to the baling chamber and the bale catches the net. The bale is then
wrapped with the predetermined net length and the net knife is tripped.
The amount of net applied can be adjusted between 1.1 and 9.9 layers per bale, using
the control box
(See ‘Net settings’) . It is recommended that a minimum of two (2) layers
of net are applied to the bale. Dry conditions and very high densities require up to four
(4) or more layers to ensure a good bale shape. The net feed arm will reset to the baling
(working) position when the tailgate is closed after releasing the bale.
If the net is not caught by the bale on the first attempt, the netting cycle can be repeated
by pressing and holding Button R3 for 3 seconds.
(See ‘Control box functions’)
7. Pull the net roll bar down onto the
roll. Adjust the roll guides equally,
allowing 2 to 4 mm clearance each
end, so the roll is centred and tighten
securely.
8. The roll of net is now threaded and
ready for baling.