McHale
Fusion Vario
Baler & Wrapper
55
t
P
P
O
P
13.
Installation is simpler, in that they only engage with the lock shaft in front and not
with the actuator arm. The knife blank is dropped into a slot, towards
the
front,
again maintaining the 5 - 10 mm gap (
G
), push forward (
P
), allowing the keyhole
slot to engage with the lock shaft. Then rotate downwards (
O
) and push forward
fully.
14.
Always observe the row of knives after installation, they should all be perfectly
aligned and at the exact same height. If one or more do not line up, then they are
not correctly positioned. Typically, the lowest and furthest forward are correct.
15.
Rotating the knife lock/unlock lever (
B
) back up to 90° onto the lock pin (
X
), locks
all knives/blanks securely.
16.
The knives are shown fully down/retracted, with the knife correctly positioned
within the actuator arm and the lock shaft in the 'locked' position with the flats
vertical (
R
). Knife tips should protrude 20 - 30 mm maximum (
T
).
R
20 - 30 mm
Max.
T
WARNING: Turn the levers back into their working position
Do not forget to turn the levers (
A
&
B
) back into their working
position(s), but only after completing all work on the machine, as above.
WARNING: Compartment doors panels must be closed while the
machine is running - danger of rotating components
Always keep the compartment door panels closed while the machine is
running because of the danger of rotating components! Take note of all
warning decals and ensure that all safety measures and precautions are
implemented before attempting to carry out any maintenance work.
