McDonald's C602, Руководство пользователя

Страница: 65 / 114

63
Freezing Cylinder Assembly—Soft Serve
Side
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
With the parts tray available for the soft serve side:
1. Before installing the soft serve beater driveshaft,
lubricate the groove on the beater driveshaft. Slide
the beater driveshaft boot seal over the small end of
the beater driveshaft and engage into the groove on
the shaft. Heavily lubricate the inside portion of the
boot seal, and also lubricate the flat end of the boot
seal that comes in contact with the rear shell bearing.
Apply an even coat of lubricant to the shaft.
Do not
lubricate the hex end. (See Figure-127.)
Figure-127
Note: When lubricating parts, use an approved

food-grade lubricant (example: Taylor Lube HP).
Note: To ensure the mix does not leak out the back of
the freezing cylinder, the middle section of the boot seal
should be convex or extend out from the seal. If the
middle section of the boot seal is concave or extending
into the middle of the seal, turn the seal inside out.

(See Figure-128.)
Figure-128
2. Insert the beater driveshaft through the rear shell
bearing in the freezing cylinder and engage the hex
end firmly in the drive coupling. (See Figure-129.)
Figure-129
WARNING! Use extreme caution when
handling the beater assembly. The scraper blades are
very sharp and may cause injury.
3. Before installing the beater assembly, inspect the
scraper blades for wear or damage. If the scraper
blades are nicked or worn, replace both blades.