McDonald's C602, Руководство пользователя

Страница: 74 / 114

72
3. Install the pump assembly at the rear of the mix
hopper. To position the pump on the drive hub, align
the drive hole in the piston with the drive crank of the
driveshaft. Secure the pump in place by slipping the
pump clip over the collar of the pump, making sure
the clip fits into the grooves in the collar.

(See Figure-163).
Figure-163
IMPORTANT! Ensure the cotter pin is installed
in the pump end of the mix feed tube. Failure to follow
this instruction could result in sanitizer spraying on the
operator
.
4. Install the pump end of the mix feed tube and secure
with the cotter pin.
5. Prepare another 2.5 gal. (9.5 L) of KAY-5
®
Sanitizer
(HCS) solution. Use one packet in 2.5 gal. (9.5 L) of
water (100 ppm).
6. Pour sanitizing solution into mix hopper.
7. Brush the exposed sides of the hopper. Wait at least
5 minutes before proceeding with these instructions.
8. Press the Wash symbol . This will cause the
sanitizing solution in the freezing cylinder to be
agitated.
9. With a pail beneath the door spout, open the draw
valve and press the Mix PUMP symbol . Open
and close the draw valve six times. Open the draw
valve and draw off the sanitizing solution.
10. Press the Wash and Mix Pump symbols and
close the draw valve. (See Figure-164.)
Figure-164
Important! The machine must not be placed in Auto
mode until all sanitizing solution has been removed from
the freezing cylinder and proper priming procedures have
been completed. Failure to follow this instruction may
result in damage to the freezing cylinder.
Note: Make sure your hands are clean and sanitized
before proceeding.
11. Place the agitator on the agitator driveshaft housing.
(See Figure-165.)
Figure-165
Note: If agitator should stop turning during normal
operation, with sanitized hands , remove agitator from
agitator driveshaft housing and brush-clean with
sanitizing solution. Install the agitator back onto the
agitator driveshaft housing.
!