McDonald's C602, Руководство пользователя

Страница: 61 / 114

59
EQUIPMENT SETUP
Freezing Cylinder Assembly—Shake Side
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
With the parts tray available for the shake side:
1. Before installing the shake beater driveshaft,
lubricate the groove on the beater driveshaft. Slide
the beater driveshaft boot seal over the small end of
the beater driveshaft and engage into the groove on
the shaft. Heavily lubricate the inside portion of the
boot seal, and also lubricate the flat end of the boot
seal that comes in contact with the rear shell bearing.
Apply an even coat of lubricant to the shaft.
Do not
lubricate the square end. (See Figure-110.)
Figure-110
Note: When lubricating parts, use an approved

food-grade lubricant (example: Taylor Lube HP).
Note: To ensure that the mix does not leak out of the
back of the freezing cylinder, the middle section of the
boot seal should be convex or extend out from the seal. If
the middle section of the boot seal is concave or
extending into the middle of the seal, turn the seal inside
out. (See Figure-111.)
Figure-111
2. Install the shake beater driveshaft through the rear
shell bearing in the freezing cylinder and engage the
square end firmly into the driveshaft coupling. Make
sure the driveshaft fits into the drive coupling without
binding. (See Figure-112.)
Figure-112
3. Check scraper blades for any nicks or signs of wear.
If any nicks are present, replace the blades.
Note: Shake side scraper blades should be replaced
every 6 months.