McDonald's C602, Руководство пользователя

Страница: 39 / 114

37
17. Inspect the duckbill valve for proper installation inside
the syrup nose fitting. The tip of the duckbill valve
must be flat to seal the syrup line. (See Figure-31.)
Figure-31
If the tip is not flat, remove the syrup nose fitting and
remove/re-install the duckbill valve. Using a shake
cup filled with
KAY-5
®
Sanitizer (HCS), rinse the
syrup nose fitting to wet the bottom of the duckbill
valve. Re-install the syrup nose fitting onto the syrup
line fitting. If the tip will not remain flat when the syrup
fitting is assembled, replace the duckbill valve.
18. Install the O-ring on the nose fitting.
19. Repeat steps 8 through 17 for all syrup flavors.
20. Each syrup flavor must be primed to purge the air out
of the syrup lines. To prime each syrup line, hold the
syrup line up, over an empty cup. (See Figure-32.)
Figure-32
21. Press the Calibrate symbol to display the menu
options. The Calibrate symbol , the Auto symbol
on the shake side, and the optional Flavor symbol
will be illuminated.
The screen will display the Calibration Menu options.
(See Figure-33.)
Figure-33
22. Press the Auto symbol or the optional Flavor
symbol to scroll the arrow to SYRUP PRIME.
(See Figure-34.)
Figure-34
23. Press the Calibrate symbol to enter the Syrup
Prime mode. (See Figure-35.)
Figure-35
24. Press the corresponding syrup Flavor symbol .
The Flavor symbol should be illuminated and the
syrup pump for the selected flavor will start running at
the maximum speed. (See Figure-36.)
Figure-36