McDonald's C602, Руководство пользователя

Страница: 62 / 114

60
4. If the blades are in good condition, place each
scraper blade over the holding pins on the beater
assembly. (See Figure-113.)
Figure-113
Note: The holes in the scraper blade must fit over the
pins to prevent damage.
5. Holding the blades on the beater assembly, insert the
beater assembly in the freezing cylinder. Engage the
shaft end firmly into the driveshaft socket.

(See Figure-114.)
Figure-114
Note: When properly seated, the beater will not protrude
beyond the front of the freezing cylinder.
6. Assemble the draw valve spinner assembly. Inspect
draw valve O-rings for cuts or nicks. (Replace if cut or
nicked.) If draw valve O-rings are in good condition,
slide the two O-rings into the grooves of the draw
valve and lubricate. (See Figure-115.)
Figure-115
7. Lubricate the outer diameter of the spinner shaft seal.
Fill the cups on each end of the seal with lubricant.
(See Figure-116.)
Figure-116
8. Insert the spinner shaft seal into the bottom of the
draw valve as far as it will go. The spinner shaft seal
should fit into the seal groove inside the draw valve
cavity. (See Figure-117.)
Figure-117