McDonald's C602, Руководство пользователя

Страница: 44 / 114

42
DAILY CLOSING PROCEDURES
Note: This procedure must be done at the close of
business.
Shake Side
Important: Fill the mix hopper with mix up to the fill level
indicator on the agitator paddle. (See Figure-52.)
Figure-52
Both sides of the freezer must be in the Auto mode (Auto
symbol is illuminated) or in the Standby mode
(Standby symbols and are illuminated) before the
Heat cycle may be started.
Note: If the Brush-Clean Counter display has counted
down to 1 day, do not add mix. The machine must be
disassembled and brush-cleaned within 24 hours.
1. Remove the hopper cover, shake cup holder, splash
shield, and drip pans.
Important! Make sure your hands are clean and
sanitized before continuing in these instructions.
Note: Select the Calibrate symbol to stop agitator
movement for 10 seconds. Select the Calibrate symbol
again to exit the Calibration mode. The agitator will
automatically restart after 10 seconds.
2. Remove the agitator from the mix hopper and the
restrictor cap from the shake freezer door spout.
3. Take the agitator, hopper cover, shake cup holder,
drip pans, front drip tray, splash shield, and restrictor
cap to the sink for further cleaning and sanitizing.
Take the syrup hole plugs, spout cap, and spout cap
O-ring to the sink for further cleaning and sanitizing.
4. Rinse these parts in cool, clean water. Draw a small
amount of SolidSense™ All Purpose Super
Concentrate (APSC) (HCS)
cleaning solution from
the sink proportioner and brush-clean the parts.
5. Place the restrictor cap, front drip tray, shake cup
holder, and splash shield on a clean, dry surface to
air-dry overnight or until the Heating cycle is
complete.
6. Prepare a small amount of KAY-5
®
Sanitizer (HCS)
solution. Use one packet in 2.5 gal. (9.5 L) of water
(100 ppm).
7. Sanitize the syrup hole plugs, spout cap, spout cap
O-ring, drip pan, agitator, and hopper cover.
8. Install the agitator back onto the agitator driveshaft
housing. Replace the hopper cover.

(See Figure-53.)
Figure-53
Important! If you do not install the agitator correctly, the
machine will fail the Heat cycle and will lock out in the
morning.
9. Remove the syrup lines from the freezer door.

(See Figure-54.)
Figure-54