MBM FC 10 PLUS, Руководство по эксплуатации

Страница: 34 / 40

33
LAMPS
(Lit/Flashing)
STATUS/CAUSE CORRECTIVE ACTION
CHECK
(Lit in green)
Normal operation Stations in use and paper thickness are checked.
PAPER JAM
(Lit in red)
If a paper jam occurs, the
corresponding station lamp and the
PAPER JAM lamp will flash. The
counter will display “Err.”
Fan out the paper well.
Select separator pressure weaker by one degree.
DOUBLE FEED
(Flashing in red)
If double feed occurs, the
corresponding station lamp and the
DOUBLE FEED lamp will flash. The
counter will display “Err.”
Fan out the sheets of paper well.
Select separator pressure stronger by one degree.
Select paper feed pressure weaker by one degree.
Double feed may occur if a mixture of paper of different
quality or differently printed paper is loaded onto a
station. Be sure to load each station with paper of only
one quality.
Remove from the stacking table extra page delivered
owing to double feed.
ENPTY FEED/
NO PAPER
(Flashing in green)
If a station in use has run out of paper
or an empty feed occurs, the
corresponding lamp will flash. In case
of empty feed, the counter will display
“Err.” In case of no paper, it will
display “End.”
Load additional paper.
Fan out the paper well.
Select feed pressure stronger by one degree.
Set paper inversely.
FULL
(Flashing in green)
If the stacking table is full of delivered
paper The counter will display
“FULL.”
Remove the paper that has filled the stacking table, or
jammed paper, and press the RESET key.
Install the stacking table properly.
Install the collator on a level place.
EJECT
(Flashing in red)
Contamination of the discharged sheet
sensor or sheet jamming.
The counter will display “Err.
Remove paper dust from right and left ejection sensors.
Remove the sheet caught in the sheet discharge portion.
DOOR
(Flashing in red)
The back door is open.
Close the back door. (Make sure it is firmly fixed)
The DOOR lamp will flash if the back door is open
while the machine is in operation. In such a case, close
the back door and press the RESET key.
Special error display
COUNTER DISPLAY STATUS/CAUSE CORRECTIVE ACTION
Err 0
Nonvolatile memory fault
If this nonvolatile memory fault frequently occurs,
contact the your dealer or authorized service
representative.
Err 1
Communication error
Check the connection between the device and the
optional unit.
Err 2
Sensor failure
Contact the your dealer or authorized service
representative.
Err 4
Both the staple and the punch are
set to OFF.
Set the staple or the punch to ON, or switch the mode to
“Independent.”