MBM FC 10 PLUS, Руководство по эксплуатации

Страница: 31 / 40

30
6. MAINTENANCE, INSPECTION, CONSUMABLES
6.1 Important for maintenance and inspection
Caution
When conducting inspections and maintenance, be sure to remove the power plug from the outlet. If not,
it may cause injury or electric shock.
6.2 Usual maintenance
・
Cleaning of paper feed rubber roller and separator is
recommended from time to time (as required).
(1) Remove the paper feed tables and auxiliary tables. While
holding the paper feed shaft, push it in to the left, then pull it
toward the front.
(2) After removing the paper feed shaft, clean its three rubber
rollers.
(3) Draw out the separator in the direction of the white arrow
shown in the figure below, and clean the rubber portion.
(4) Install the paper feed shaft in the way reverse to how
it was removed.
Should trouble such as double feed, no feed, etc. occur after cleaning, the rubber paper feed
rollers and separator are worn. Replace them with new ones referring to the previous page.
When the paper feed rubber rollers are replaced, mount them on the paper feed rollers holders
so that the white dot of the rubber rollers is on the right-hand side. In addition, after mounting
the paper feed rollers on their holders, roll them on a flat surface such as a desktop to make
sure they are mounted horizontally. If mounted askew, problems like paper feed failure or
double feed may occur. Be watchful of the paper detection wire when replacing the feed
rollers.
Cleaning the exterior
Wipe off any stains using a cloth dampened with diluted neutral detergent and wrung tightly.
Remarks
Do not use solvent cleaning liquids as they may cause discoloring.
Separator