MBM FC 10 PLUS, Руководство по эксплуатации

Страница: 17 / 40

16
4.1.4 Stacking table
(1) Fit the tumbler-shaped hooks on the stacking table into
the hooks of the front foot rubber base (two places)
while fitting the tip notch of the stacking table to the
collator’s crisscross roller, then tilt the stacker table on
either right or left side (right with the roller on the right,
left when on the left), and insert the stacking table
hooks in the opening on the front foot rubber base.
Make sure the hooks are firmly fitted on both right and
left sides.
Caution!
If the depressed portion on the stacking table is not
properly set in the crisscross roller, “LOCK” will be
indicated on the Counter display when the CHECK key
or START key is pressed. If the machine is continuously
operated in this way, it may cause a breakdown of the
crisscross motor. In such a case, turn off the power,,
and after the stacking table is removed from the
machine, start the machine again to perform normal
operation and confirm that the crisscross roller moves
from side to side and “LOCK” is not shown on the
display. Then, reset the machine properly in
accordance with the instructions specified in the
Operation Manual.
(If the crisscross roller moves from side to side even
after the stacking table is removed, contact your dealer.)
If the
CRISS-CROSS/5
key is pressed for three seconds after the
MODE key is pressed, the crisscross roller will perform one
operation.
(2) Install the aligning wire.
[1]After installing the stacking table in the collator,
insert the rear part of the aligning wire into the wire
insertion hole in the collator.
[2]Pinch the bent part at the aligning wire tip with your
fingers and draw it to the front. Then, fit it on the
wire insertion hole in the stacking table.
[3]While pinching the wire as it is, insert the bent part
at the wire tip into the wire insertion hole in the
stacking table.
Remarks
a) Make sure the stacking table and aligning wire are
properly attached to the machine; wrong attachment
may cause the machine to rock or paper to jam when
ejected.
b) Take care so that fingers or hands are not caught in
collator operating parts.
Caution!
Make sure that the paper feed table, the auxiliary table and the stacking table are properly set.
They may cause an injury if they come off. Also, take care not to cause the machine to fall when
attaching or removing the stacking table and auxiliary table.