MBM FC 10 PLUS, Руководство по эксплуатации

Страница: 27 / 40

26
5.7 Programmed insert mode
Programmed insert mode functions to insert front covers
loaded on the top station and back covers on the bottom
station according to a predetermined number of sets,
making it easy to prepare chits.
(1) Select the mode by pressing the MODE key.
( MODE lamp will light)
(2) Press the PROGRAM/8 key for three seconds; the
Counter lamp will flash. Then, input the number of
sets to be collated.
<Example>
When “10” is input as the number of sets, front and
back covers are inserted in each batch (10 collated
sets) of set.
(3) Press the MODE key to change the display beside the
Counter from SHEET to SET, then input the number of
batches.
<Example>
When “5” is input as the number of batches, the
machine stops operation after 5 batches (5 chits) are
processed.
(4) Press the MODE key again; the Counter will again
light showing the number of sets previously input.
Note
a) If “0” is input as the number of batches while SET is
selected, programmed insert mode collation will
continue until the station runs out of paper.
b) To confirm the number of batches, keep pressing the
MODE key in programmed insert mode; this will
display the figure.
c) Two or more Chit mode data can be stored. For
details, see 5.8 “Storing Insert/Programmed Insert
mode data.”
(5) Setting front and back covers
Be sure to load paper with the printed side up.
For example, when 10 stations to be used continuously
top to bottom, front covers should be loaded on Station 1,
back covers on Station 10.
If fewer than 10 stations are used, load front covers on
the top station, back covers on the lowest of those to be
used.