Magnetek GPD 205, Техническое руководство

Страница: 52 / 88

C Co on ns stta an ntt S Stta allll P Prre ev ve en nttiio on n L Le ev ve ell Range: 30 - 200 (%)
n n 3 3 5 5 A Att S Se ett S Sp pe ee ed d Factory Setting: 160
This constant determines the actual GPD 205 output current level while operating at
set speed (frequency). Set in percent of GPD 205 rated output current (see
Appendix 1).
A setting of “ 200 ” disables
stall prevention at set speed.
During running at set speed, if
the output current exceeds
the value set in n
n 3 3 5 5 , the
drive will begin to decelerate.
When the output current goes
below the value set in n
n 3 3 5 5 ,
acceleration begins, up to the
set frequency.
C Co on ns stta an ntt M Mo om me en ntta arry y P Po ow we err L Lo os ss s Factory Setting: 0
n n 3 3 6 6
F Fu un nc cttiio on n S Se elle ec cttiio on n
This constant determines how the momentary power loss ride-thru function of the
GPD 205 will operate.
Setting Function
0 Operation during momentary power loss disabled
1 Operation during momentary power loss enabled —
0.5 sec. power loss ride-thru
( “
U u ” displayed during power loss)
2 Operation during momentary power loss enabled —
indefinite power loss ride-thru, provided control power
is maintained
( “
U u ” displayed during power loss; no fault signal is
output at control circuit terminals MA & MB or PA)
43
t
t
MOTOR
CURRENT
OUTPUT
FREQ.
Constant
n35
setting
for more: efesotomasyon - Yaskawa drive