138
6. While pressing the hook stowage switch on the machine
monitor, once more slowly operate the right work
equipment operation lever (3) to the “Hoisting” side (pull
toward you) and slowly and carefully hoist the hook
block (4) to store it in the lower part of the boom tip.
NOTES
When the hook stowage switch is pressed, the red lamp
on the tri-colour revolving working status lamp turns on.
NOTES
The right figure shows a state in which the hook block (4)
is stored in the lower part of the boom tip.
NOTES
• The right figure shows the state in which the hook block
(4) is stored in the lower part of the boom tip when the
boom angle is 70 degrees or more.
• To stow the hook block with a boom angle of 70 degrees
or more, fully retract the boom as in step 1 and refer to
“Operation 3.14 Boom Derricking Operation” to set the
boom angle to 70 degrees or more. Next, continue
operations from step 4.
Содержание CC423S-1
