176
8.3.3 CAUTIONS IN CHARGING BATTERY
There is a risk that the battery may explode if handled
incorrectly during charging, so follow “Operation 8.3.1
Battery Handling Precautions”, and the instruction manual
attached to the charger, while strictly observing the items
below.
• Flammable hydrogen gas is generated when charging
the battery, so remove it from the machine and remove
the battery cap in a well ventilated area before charging.
• Securely tighten the battery cap afterwards. If the battery
cap is damaged, replace it immediately.
• Adjust the charger voltage to suit the voltage of the
battery to charge. Mistakes in setting the voltage may
cause the charger to overheat and ignite, resulting in an
explosion.
• Securely fix the (+) charge clip of the charger to the (+) terminal of the battery, then securely fix the (
−
)
charge clip to (
−
) terminal of the battery.
• Set the charge current to no more than 1/10 of the rated capacity of the battery, or, in case of quick
charger, set to the rated capacity value of the battery or smaller.
Excessive charge current may cause fire and explosions due to fluid leaks or fluid deficiency.
• If the battery fluid is frozen, do not charge the battery or start the engine using other power source. This
may cause the battery to catch fire and explode.
• If the battery fluid level decreases to the LOWER LEVEL or below, do not use the battery or recharge it.
An explosion may occur. Never fail to conduct the regular inspection of battery fluid level and refill
purified water (such as commercially available battery replenisher) to the UPPER LEVEL.
Содержание CC423S-1
