Maeda CC423S-1, Руководство по эксплуатации

Страница: 219 / 278

211
[4] CLEANING ELEMENT OF WATER SEPARATOR
Keep away from flame.
• Have a filter wrench available.
• Prepare a container to receive the drained fuel.
1. Open the engine bonnet.
2. Turn the handle (1) of the water separator to the closed
position (A).
3. Loosen the drain plug (2), drain the accumulated
moisture to the container until the red ring (3) hits the
bottom, and then close the plug (2).
4. Loosen the ring (4) using a filter wrench, remove the
element cup (5), and then remove the element (6). Take
care not to lose the red ring (3) inside the cup.
5. Clean the interior of the cup (5) and the element (6) with
diesel fuel or cleaning oil.
6. Install the element (6) after cleaning.
7. Put the red ring (3) into the element cup (5), fill it with
fuel, attach it to the filter base, and tighten the ring (4).
Tightening torque: 14.7 to 19.6 N · m (1.5 to 2.0 kg · m)
8. Turn the handle (1) of the water separator to the open
position (B).
9. Remove the air after cleaning the water separator. For
air removal procedure, refer to “Inspection and
Maintenance 10.7 Maintenance Every 500 Hours [2]
Replacement of Main Fuel Filter”.