Maeda CC423S-1, Руководство по эксплуатации

Страница: 215 / 278

207
CAUTION
For the coolant, use genuine Maeda super coolant (AF-NAC). Use of any other coolants than
genuine Maeda super coolant (AF-NAC) is not recommended in principle.
Always use tap water when diluting. Contact us or our sales service agency if river water, well water, or
water through the small water-supply system is necessarily substituted for tap water.
The mixing proportion of super coolant is recommended to be controlled by using the super coolant
concentration meter.
Provide a container with a capacity of 5.5 litres or more for the coolant.
1. Open the gravel cover on the right side of the vehicle.
2. Ensure that the surface temperature of the radiator cap
(1) is as low as can be touched with a bare hand, and
slowly turn it until it comes into contact with the stopper
to relieve the internal pressure.
3. Further, remove the radiator cap (1) while turning it
until it comes into contact with the stopper.
4. Open the cover (2) on the lower right side of the
vehicle.
5. Place a container underneath the drain valve (3) and
the engine cylinder block drain plug (4) to collect the
coolant.
6. Open the drain valve (3) and drain the coolant.
Remove the drain plug (4) and drain the coolant.
7. After draining, close the drain valve (3) and the drain
plug (4), and inject tap water; when the radiator is filled
with water, start the engine, put it in low idling state,
raise the water temperature to 90 ºC, and run it for
approximately 10 minutes.
8. Stop the engine, open the drain valve (3), remove the
drain plug (4), and drain the coolant.
9. After draining, clean it using cleaning agent. Clean
according to instructions provided on the cleaning
agent used.
10. Close the drain valve (3) and wrap a sealing tape
around the drain plug (4) to close it.
11. Inject super coolant and tap water from the water inlet
up to the mouth. For the mixing proportion of water and
the super coolant, refer to the “Table of mixing
proportion of water and super coolant”.