MacDon TR41 S, Руководство оператора, Страница: 50 / 80

Commissioning
48
To adjust the tilt of the alignment gauge, pull the alignment gauge up
against the spring, and after adjusting the desired tilt, release it so that the
locking screw Nr.5 fits into the appropriate groove.
7. Slowly lower the header while the front of it touches the support beam.
8. Slowly lower the header further while constantly monitoring that the header
is in the correct position.
9. If the back of the header is not positioned well in relation to the brackets,
raise the header completely again, then move it on the appropriate position
and try to place it on the trailer again.
10. Lower the feeder house until the feeder hook is released, then gently
reverse with the combine.
11. After placing the header on the trailer, remove the retaining pin Nr.2, turn
the alignment gauge parallel to the beam and set the alignment gauge back
to the first groove and set it to the holder Nr.3.
5
6
3
1
2