MacDon TR41 S, Руководство оператора, Страница: 49 / 80

Commissioning
47
7.7 Attaching the header to the trailer
After completing the previous steps, place the header on the trailer as
follows:
1. Stop the header drive.
2. Disconnect the header from the combine (hydraulic and mechanical
couplers).
3. Set the header snouts (if available) to shipping positions, put the vertical
knives (if available) into the storage box.
4. Approach the trailer from the left in the direction of travel.
5. Raise the header with the combine until the header fits securely over the
brackets.
6. Drive straight ahead with the combine or the tractor until the front of the
header is above the support beam. Use the header alignment gauge Nr.2
as a reference point. Check that the back of the header is exactly above the
brackets Nr.1.
To use the alignment gauge Nr.2, remove the retaining pin Nr.3, take the
alignment gauge out of the support Nr.4 and pull the alignment gauge out
of the support tube. Turn the alignment gauge 90 degrees and then put the
retaining pin back into the corresponding hole.
2
1
4
3