MacDon D65, Инструкция по сборке, Страница: 68 / 110

214328
60
Revision A
Figure 5.18: Double-Knife Center Stub Guard
Hold-Down
5. Double-knife center stub guard: Manually stroke
knife to locate sections under hold-down (B).
6. Measure clearance between knife sections (A) and (C)
with a feeler gauge. The clearance should be as
follows:
•
At hold-down tip (E): 0.1
–
0.4 mm (0.004
–
0.016 in.)
•
At rear of hold-down (F): 0.1
–
1.0 mm
(0.004
–
0.040 in.)
7. If necessary, refer to Adjusting Stub Guard Hold-
Downs, page 60 .
Adjusting Stub Guard Hold-Downs
WARNING
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
before making adjustments to machine.
1. Shut down windrower, and remove key from ignition.
Forged hold-down:
Figure 5.19: Normal Stub Guard Forged Hold-
Down
2. Manually stroke knife to center section(s) (A) under
hold-down (B) as shown.
3. Loosen nuts (C) and back off bolts (D) clear of
cutterbar.
4. Lightly clamp hold-down (B) to guard (E) with a C-clamp
or equivalent. Position clamp on trash-bar at (F).
5. Turn bolts (D) until they contact cutterbar, then tighten
ONE turn.
6. Remove clamp.
7. Tighten nuts (B) and torque to 45 Nm (35 lbf·ft).
8. Check that specified clearances are achieved. Refer to
5.7.2 Checking Stub Guard Hold-Downs, page 59 .
PERFORMING PREDELIVERY CHECKS