MacDon D65, Инструкция по сборке, Страница: 17 / 110

214328
9
Revision A
Figure 2.6: Blocks at Each End and Center
of Cutterbar
5. Place 150 mm (6 in.) blocks (A) under each end and
center of cutterbar. Lower header onto blocks.
6. Remove chain and move lifting vehicle to rear
of header.
7. Attach chain to center-link anchor on frame tube and
raise rear of header so that stand can be lowered.
Figure 2.7: Header Stand
8. Lower header stand: pull pin (A), lower stand (B), and
releasing pin (A) to secure stand in place.
9. Lower header onto stand.
NOTE:
If ground is soft, place a block under the stand.
10. Remove chain.
2.2.2 Lowering Double-Reel Header
Reposition header in preparation for assembly and setup as follows:
Figure 2.8: Header on Shipping Stands
1. Choose an area with level ground.
2. Drive lifting vehicle to approach header from
its underside.
UNLOADING HEADER