Lynx SMART30, Руководство пользователя

Страница: 16 / 48

Grills set up for liquid propane gas come equipped with a liquid
propane hose/regulator assembly for connec on to a standard
20 lb. liquid propane cylinder (Type 1). All fi ngs necessary to
a ach the assembly to the grill are included.
LIQUID PROPANE GAS
WARNING
Do not change the regulator/hose assembly or use any
other assembly than the one supplied with your Lynx
SmartGrill by Lynx
™
.
Do not a empt to use a 5LP ‐ A equipped regulator/hose
assembly with a standard 510 POL cylinder/valve
assembly.
Do not store a spare liquid propane gas cylinder under or
near this appliance.
Never fi ll the cylinder beyond 80 percent full
If the informa on above is not followed exactly, a fi re
causing death or serious injury may occur.
GAS CONNECTIONS... con nued
LP cylinder with
type 1 valve
connec on
Permanently plumbed liquid propane connec ons, such as
those in line with a bulk cylinder, require a 4/11 regulator.
(Lynx P/N 30781)
When using the 4/11 regulator, you must ensure that it is set
for the proper fuel type. This is done by removing the regulator
cap and gasket and looking at the bo om of the plunger to see
what fuel type is visible. This is the regulator fuel se ng. NAT is
for natural gas and LP is for propane gas. The LP se ng can be
further iden fi ed by the large diameter disk on the bo om of
the plunger. To change from one gas to the other, simply push
the plunger to the side to snap it out of the cap, turn the plung ‐
er so it reads the desired gas type on the bo om, and push the
plunger un l it snaps back into place in the cap and then re ‐
place the cap into the regulator.
Cylinders of free standing grills must be secured using the pro ‐
vided cylinder reten on system to avoid accidental movement.
Make sure the hose between the grill and the
NEVER CONNECT AN UNREGULATED GAS LINE TO THE GRILL.
Liquid Propane Cylinder Requirements
The liquid propane cylinder must be constructed and marked in
accordance with the speci fi ca ons for liquid propane gas cylin ‐
ders of the U.S. Department of Transporta on (DOT) and de ‐
signed for use with a Type 1 system only.
propane bo le does not touch the back or bo om of the
fi rebox.
When exchanging your cylinder for a re fi ll, exchange only
for a Type 1 20lb cylinder with an over ‐ fi ll protec on device.
Never use a cylinder with a damaged valve.
A dented or rusty LP cylinder may be hazardous and should
be avoided. If in doubt, have it checked by your liquid
propane supplier.
Always check for leaks a er every liquid propane cylinder
change. (See INDEX: “Leak Test” for further details.)
Always shut o ff the liquid propane gas supply at the cylinder
when the SmartGrill is
not in use.
Cylinders must be
stored outdoors in a
well ‐ ven lated area
out of the reach of
children. If your grill is stored indoors, the liquid propane
cylinder must be stored outside.
Liquid Propane Connec ons
Make sure the liquid propane cylinder valve is completely
closed. It is possible for the valve to be opened without
releasing gas, but as soon as you start connec ng the regula ‐
tor, gas can fl ow from the connec on.
Insert the regulator inlet into the cylinder valve and turn
the black coupler clockwise un l the coupler is hand ght.
Do not over ‐ ghten this connec on.
To disconnect the coupler, fi rst make sure the main cylinder
valve is turned o ff . Grasp the coupler and turn counter ‐
clockwise. The inlet will then disengage.