2.1EN-38021-D09
Page 22 of 34
User Manual
Installation and Operating Instructions
Subject to modificaitons
Form 403013
Display of pa ramete rs and states
Pre ss
>2 sec.
4214a 99
Display
42 82a00
a fter 2 sec.
430 0a00
Â
Press bu tton, so that “Pi“ app ears in t he display.
6 001a0 2
NOTE
The following display sequ ence is shown
twi ce and is cancelled afte r 60 seco nds.
The change of display occu rs every two
seconds.
Example:
Pi
(preset lubricating time min )
= 4 minutes
Pb
(preset st and-by time h)
= 12 hours
rb
(residual stand-by time h & min)
= 10 h 09 min
Pi .
0 4
p reset lub ricating time
4 minutes
afte r 2 sec.
after 2 sec.
42 99a00
42 16a99
Pb 12
.
p reset sta nd-by time
12 hours
afte r 2 sec.
after 2 sec.
42 83a00
42 84a00
Example 10 h 09 min
rb 10
.
residual st and-by time
10 hours
after
2
sec.
42 85a00
Fig. 13-3 Display of parameters and states
(continuation next page)
. 0 9
+
9
minutes
Triggering an additiona l lubrica tion cycle
Press Displa y
>2 sec
4222 a99
4 209a9 9
Fig. 13-2 Triggering an additional lubrication cycle
Precond ition:
Â
Reset the pre se nt stand-by time:
- Couple (semi-) trailer to the traction vehicle.
- Provide voltage supply bet ween (semi-) traile r and t rac-
tion vehicle.
- Switch on driving switch an d actua te brake pedal.
- Hit the re servoir slightly by hand to start th e motion
sensor.
Â
Press pu sh button > 2 seco nds to trig ger an additional
lubrica tion cycle (Fig . 13-2).
The lubricatin g time starts running. Th e whole run time
th rough a rotating segment is visible on the displa y. At the
same time th e pause time already la psed is reset.
Setting and Operation, continuation