Lenovo ThinkSystem SR530, Руководство по обслуживанию

Страница: 137 / 184

Install a processor and heat sink
This task has instructions for installing an assembled processor and heat sink, known as a processor-heat-
sink module (PHM), a processor, and a heat sink. All of these tasks require a Torx T30 driver.
“
Read
the
installation
Guidelines” on
page 45
“
Power off
the server
for this task”
on page 14
“
ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 48
Attention:
• Intel Xeon SP Gen 2 processors are supported on the system board with part number 01PE840. If you use
the system board with part number 00MX681, update your system firmware to the latest level before
installing a Intel Xeon SP Gen 2 processor. Otherwise, the system cannot be powered on.
• Each processor socket must always contain a cover or a PHM. When removing or installing a PHM,
protect empty processor sockets with a cover.
• Do not touch the processor socket or processor contacts. Processor-socket contacts are very fragile and
easily damaged. Contaminants on the processor contacts, such as oil from your skin, can cause
connection failures.
• Remove and install only one PHM at a time. If the system board supports multiple processors, install the
PHMs starting with the first processor socket.
• Do not allow the thermal grease on the processor or heat sink to come in contact with anything. Contact
with any surface can compromise the thermal grease, rendering it ineffective. Thermal grease can damage
components, such as electrical connectors in the processor socket. Do not remove the grease cover from
a heat sink until you are instructed to do so.
• To ensure the best performance, check the manufacturing date on the new heat sink and make sure it
does not exceed 2 years. Otherwise, wipe off the existing thermal grease and apply the new grease onto it
for optimal thermal performance.
Notes:
• PHMs are keyed for the socket where they can be installed and for their orientation in the socket.
• See
https://static.lenovo.com/us/en/serverproven/index.shtml
for a list of processors supported for your
server. All processors on the system board must have the same speed, number of cores, and frequency.
• If you are going to install one of the following processors, replace your heat sink with a heat pipe heat sink
(part number: 01KP650 or 01KP651):
– Intel Xeon Platinum 8156 4C 105W 3.6 GHz processor
– Intel Xeon Platinum 8256 4C 105W 3.8 GHz processor
– Intel Xeon Gold 5120T 14C 105W 2.2 GHz processor
– Intel Xeon Gold 5122 4C 105W 3.6 GHz processor
– Intel Xeon Gold 5217 8C 115W 3.0 GHz processor
– Intel Xeon Gold 5218T 16C 105W 2.1GHz processor
– Intel Xeon Gold 5220T 18C 105W 2.2 GHz processor
– Intel Xeon Gold 5222 4C 105W 3.8 GHz processor
– Intel Xeon Gold 6126T 12C 125W 2.6 GHz processor
– Intel Xeon Gold 6128 6C 115W 3.4 GHz processor
– Intel Xeon Gold 6130T 16C 125W 2.1 GHz processor
– Intel Xeon Gold 6138T 20C 125W 2.0 GHz processor
Chapter 3
.
Hardware replacement procedures
129