Lenovo ThinkSystem NE0152T, Руководство по установке

Страница: 62 / 110

62
NE0152T Installation Guide
Replacing the Fan Module
To replace a hot-swap fan module, complete the following steps:
1.
Select an empty fan module bay on the rear of the switch. If the target bay is
covered by a blank fan filler plate, loosen the retainer screw and slide the filler plate
out of the slot.
2. Remove the new fan module from the antistatic shielded bag.
3. Slide the fan module into the card guides in the open slot and gently push it all the
way into the slot, so that it firmly engages with the connector (see the illustration).
Each fan module has a mechanical guide key to prevent you from inserting the
module incorrectly.
4.
Tighten the retaining screw on the fan module. Torque the screw to approximately
0.25 Nm +/- 0.1 Nm (2 inch-pounds).
5.
Make sure that the fan module’s LED is lit.
Retainer Screw