Lenovo ThinkSystem NE0152T, Руководство по установке

Страница: 22 / 110

22
NE0152T Installation Guide
RJ45 Management Port
The RJ45 management port on the front panel supports 10/100/1000 Mbps BASE-T,
in-line switch management.
To attach an RJ45 connector to the switch, push the RJ45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
RJ45 Management LEDs
The RJ45 management port LEDs are oriented as shown in the following figure.
Figure 5.
RJ45 management port LEDs
Status LEDs for the RJ45 management port are described in the following table.
Reset Button
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
 Normal reset—press and release the Reset button. The switch starts a forced
reload procedure without saving the current running configuration. This action
is intended for when the switch is unresponsive and needs to be restarted to
resume its normal functions.
 Factory reset—press and hold the Reset button for more than five seconds. The
switch reloads and reverts all its configuration settings to the factory defaults.
Table 3.
RJ45 status LEDs behavior
LED State Functional Meaning
Link Steady Green Link up
Flashing Green Packet transmitting or receiving
Off Link down or port disabled
Speed
Steady Green 100/1000 Mbps connection
Off 10 Mbps connection or no link
Speed LED
Link LED