Lenovo ThinkServer RD350G, Руководство пользователя и руководство по техническому обслуживанию аппаратного обеспечения

Страница: 64 / 186

3. Check and configure the BIOS settings for your specific needs. See
“Using the Setup Utility
program” on page 43.
•
Using the BIOS recovery jumper
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See
“Removing or extending the server from the rack cabinet” on page 57.
3. Remove the server cover. See
“Removing the server cover” on page 57.
4. Locate the BIOS recovery jumper on the system board. See
“System board jumpers” on page 36.
Then, remove any parts and disconnect any cables that might impede your access to the jumper.
Note: Do not remove the memory modules or microprocessors.
5. Remove the jumper cap from the jumper cap storage. See
“System board jumpers” on page 36.
6. Note the orientation of the jumper cap and then install the jumper cap on the BIOS recovery jumper.
7. Connect the server to an ac power source. The server turns on and then turns off automatically.
8. Move the jumper cap back to the jumper cap storage. See
“System board jumpers” on page 36.
9. Wait for about 20 minutes for the TSM to recover the BIOS. To prevent permanent damage, DO
NOT TURN OFF THE SERVER during the recovery process. When the BIOS recovery process is
completed, the server turns on automatically.
10. Ensure that the Setup Utility program starts normally. See
“Starting the Setup Utility program” on
page 43. Then, disconnect the server from the ac power source.
11. Reinstall any parts and reconnect any cables. Then, reinstall the server cover. See
“Completing
the parts replacement” on page 142.
12. Connect the server to an ac power source and turn on the server. Check and configure the BIOS
settings for your specific needs. See
“Using the Setup Utility program” on page 43.
Note: If you cannot recover the BIOS after using the instructions in this topic, the BIOS read-only memory
(ROM) might be damaged. You must replace the system board. Contact the Lenovo Customer Support
Center.
Configuring RAID
This topic provides information about RAID and the utility programs that are available for you to configure
RAID.
This topic contains the following information:
• “About RAID” on page 50
• “Configuring RAID using the Lenovo ThinkServer Deployment Manager program” on page 52
• “Configuring the advanced SATA or SAS hardware RAID” on page 52
About RAID
RAID, an acronym for Redundant Array of Independent Disks, is a technology that provides increased
storage functions and reliability through redundancy. This is achieved by combining multiple hard disk drives
into a logical unit, where data is distributed across the drives in one of several ways called RAID levels.
When a group of independent physical hard disk drives are set up to use RAID technology, they are in a
RAID array. This array distributes data across multiple hard disk drives, but the array appears to the host
50
ThinkServer RD350G User Guide and Hardware Maintenance Manual