Lenovo 7D7Q, Руководство по обслуживанию

Страница: 145 / 184

Figure 123. VGA cable installation
a. Insert the VGA cable into the front I/O assembly.
b. Install and fasten two screws to secure the VGA cable.
After you finish
1. Install the front operator panel (2.5-inch drive model). See “Install the front operator panel (2.5-inch drive
model)” on page 82 .
2. Install the top cover onto the server. See “Install the top cover” on page 134 .
3. Complete the parts replacement. See “Complete the parts replacement” on page 140 .
Remove the VGA cable (3.5-inch drive model)
Use this information to remove the VGA cable for the 3.5-inch drive model.
About this task
Attention:
• Read the following section(s) to ensure that you work safely.
– “Safety” on page iii
– “Installation Guidelines” on page 51
• Turn off the server. Disconnect the power cords and all external cables. See “Power off the server” on
page 11 .
• If the server is installed in a rack, remove the server from the rack.
Watch the procedure
A video of this procedure is available at YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
BPZOAqQMD37KjuxaVHVBkH
.
Procedure
Step 1. Make preparations for this task.
a. Remove the top cover. See “Remove the top cover” on page 132 .
b. Disconnect the VGA cable. See “Front panel cable routing” on page 35 .
Step 2. Remove the VGA cover.
Chapter 4
.
Hardware replacement procedures
137