Lennox e-Baltic D BOX 55, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 92

INTRODUCTION
e-BALTIC-IOM-2020.12-EN
10
DELIVERY CHECKS
On receipt of a new equipment please check the following points. It is the customer ’ s responsibility to ensure that the products
are in good working order:
•
The exterior has not been damaged in any way.
•
The lifting and handling equipment are suitable for the equipment and comply with the specifications of the handling
instructions enclosed here-in.
•
Accessories ordered for on-site installation have been delivered and are in good working order.
•
The equipment supplied corresponds to the order and matches the delivery note.
If the product is damaged, exact details must be confirmed in writing by registered post to the shipping company within 48
hours of delivery (working days). A copy of the letter must be addressed to Lennox and the supplier or distributor for
information purposes. Failure to comply will invalidate any claim against the shipping company.
RATING PLATE
The rating plate provides a complete reference for the model and
ensures that the unit corresponds to the model ordered. It states the
electrical power consumption of the unit on start-up, its rated power
and its supply voltage. The supply voltage must not deviate beyond:
+5/-5%. The start-up power is the maximum value likely to be achieved
for the specified operational voltage. The customer must have a
suitable electrical supply. It is therefore important to check whether
the supply voltage stated on the unit's rating plate is compatible with
that of the mains electrical supply. The rating plate also states:
•
year of manufacture
•
weight of the unit
•
type of refrigerant used + GWP*
(*Global warming potential)
•
required charge for each circuit
•
operating Pressure min/max
•
operating Temperature min/max
CE marking: 7 possible cases
-
CE -CE0038 or CE0094
-
CE1312 -CE0038 or CE1312
- Absence of CE marking (outside the EC only)
STORAGE
When units are delivered on site they are not always required immediately and are sometimes put into storage. In the event
of medium to long-term storage, we recommend the following procedures:
•
Ensure that there is no water in the hydraulic systems (for water condensing rooftops)
•
Keep the heat exchanger protection if any.
•
Keep protective plastic film in position.
•
Ensure the electrical panels are closed.
•
Keep all items and options supplied in a dry and clean place for future assembly before using the equipment.
•
Store the unit on an appropriate place (flat surface).
•
Storage temperature must be respected according to the information given on the rating plate
It is strongly recommended to store units is a dry, sheltered place (in particular for units that will be installed indoor).