8: Device Ports
SecureLinx SLC User Guide
66
Break Sequence
A series of one to ten characters users can enter on the
command line interface to send a break signal to the external
device. A suggested value is
Esc+B
(escape key, then
uppercase “B” performed quickly but not simultaneously).
You would specify this value as
\x1bB
,
which is hexadecimal
(\x)
character 27
(
1B
) followed by a
B
.
Logging
Click the
Settings
link to configure file logging, email logging,
local logging, and PC Card logging. (See
Device Ports –
Logging
on page 74
.
)
Zero Port Counters
Resets all of the numerical values in the Port Counters table
at the bottom of the page to zero (0).
Connected to
The type of device connected to the device port. Presently,
the SLC supports Lantronix’s SecureLinx Remote Power
Manager (SLP8 and SLP16). If the type of device is not
listed, select
undefined
.
If you select SLP8 or SLP16, click
Commands
. The Device
Ports – SLP web page displays.
Enable Telnet In
Enables access to this port through Telnet. Disabled by
default.
Enable SSH In
Enables access to this port through SSH. Disabled by
default.
Enable TCP in
Enables access to this port through a raw TCP connection.
Disabled by default.
Note:
When using raw TCP connections to transmit binary
data, or where the break command (escape sequence) is not
required, set the Break Sequence of the respective device
port to null (clear it).
Port
Automatically assigned Telnet, SSH, and TCP port numbers.
(See
8: Device Ports
for information on setting up the
numbering scheme.) You may override this value, if desired.
Authenticate
If selected, the SLC requires user authentication before
granting access to the port.
Authenticate
is selected by
default for
Telnet in
and
SSH in,
but not for
TCP in
.
IP Address
IP address used for this device port so a user can Telnet,
SSH, or establish a raw TCP connection to this address and
connect directly to the device port.
For Telnet and SSH, the default TCP port numbers (22 and
23, respectively) are used to connect to the device port. For
raw TCP, the TCP port number defined for
TCP In
to the
device port is used.
