LANDINI 5860, Руководство по эксплуатации и обслуживанию

Страница: 40 / 132

36
Operation
Power take-off clutch
Gearshift-power take-off clutch lever (A-Fig. 11):
•
Pos. ON down = PTO engaged
•
Pos. OFF up = PTO disengaged.
Pull the lever to its coupling point to disengage the PTO
clutch. To engage it, release the lever by pressing on
the control on the lever itself
.
Warning: to avoid accidents, always make
sure that all PTO guards are in position and
stay well clear of the drivelines when using the
PTO.
Warning: before driving an implement
through the PTO, always make sure that all
bystanders are well away from the tractor.
Warning: always disengage the PTO and stop
the engine before connecting, disconnecting or
adjusting the implements that are connected to
it.
Warning: fix the drawbar in the central
position when using implements that are
driven by the PTO of the tractor.
Power take-off
The tractor is equipped with a power take off (D) (Fig.
13) that complies with international regulations. It is
installed at the rear of the transmission housing.
The PTO shaft (D) can be driven in either of two ways:
• directly from the engine: independent PTO
mode;
• via the gearbox: synchronized ground drive PTO
mode.
The PTO (Fig. 12) is engaged in the following way by
using the lever (B):
• disengage the relative clutch by bringing the
control lever (A) to the OFF position. A ratchet
will retain the lever in this position;
• set the PTO engaging lever (B) to the required
position after a few seconds.
Fig. 12
Fig. 11
PTO engaging lever.
Independent PTO engaged - Lever B
back .
PTO in neutral position - Lever B in
center.
Synchronized PTO engaged - Lever B
forwards .