LANDINI 5860, Руководство по эксплуатации и обслуживанию

Страница: 20 / 132

Safety notes
5.
Economy PTO.
As shown in the Operation and Maintenance
Manual, the economy PTO on large tractors is a
feature that makes it possible to use the PTO at
standard speed using lower RPM rates.
This feature can only be used when the imple-
ments powered by the PTO are to be used only for
light operations, such as for sprinklers or rakes,
which require less than 30 H.P.
The economy PTO does not need to use the
maximum power of the engine but it is designed to
save fuel.
6.
Working on slopes.
The Operation and Maintenance Manual provides
information on using the tractor on slopes in
conditions of safety.
It is also important to note that, when working on
very steep slopes, the lubrication conditions in the
transmission may be reduced. This is caused by
the oil flowing towards the front or rear part of the
transmission unit.
Special measures and extra lubrication may be
required when using the tractor in conditions of
safety.
Your dealer will be able to assist you if you expect
to work on slopes of over 15°.
7.
Remote hydraulic controls.
The hydraulic system of the tractor may be used in
some particular applications to operate the hydrau-
lic motors.
When using these applications, note that the
hydraulic motors can generate considerable heat
and the oil cooling system of the tractor may not
be sufficient when these high-power hydraulic
motors are used.
Some remote applications have an extra cooling
system. However, every time they are used, make
sure that the oil is cooled and filtered sufficiently in
order to avoid damage to the tractor's hydraulic
system.
8.
Towing heavy loads (trailers, etc.)
When towing heavy loads at high speed, it may be
necessary to have a supplementary braking system
(e.g. trailer brakes) and greater ballast on the rear
wheels in order to ensure sufficient braking power
on the rear axle.
Consult your dealer for any further requirements
there may be for special applications.
9.
Operating a dry-disc clutch.
Most tractors with a manual gearshift are equipped
with a dry-disc clutch for changing gear.
Since the clutch slips every time the gear is
changed, it can cause a certain amount of wear
and thus create heat. To ensure long life for the
clutch, it is thus advisable to reduce the load of the
tractor and reduce engine speed when starting up
the tractor from a standing position.
Prolonged slipping at high engine speed with large
loads will cause the clutch disc to heat up, thereby
reducing its working life.
10.
Further instructions for the operator.
The Operation and Maintenance Manual provides
instructions to ensure that the tractor is always
used in conditions of safety.
If your tractor is also driven by other people, make
sure that they are fully aware of these accident
prevention instructions.
Passengers may only be carried on the tractor if
they are sitting on a special passenger seat and
have their seat belt fastened.
It is forbidden to carry anyone on the outer struc-
ture of the tractor in any circumstances.
This is because the safety frame is only designed
to protect persons inside the cab or the safety
frame.
If the tractor is equipped with a safety frame alone,
it is inadvisable to transport passengers even using
a special passenger seat.
11.
Chemical filters for the cab.
Use of a filter with chemical absorbent in air-
conditioned cabs can increase the degree of
protection in certain applications but you must
always read and understand the label on the
chemical product to be used.
WARNING: PERSONAL PROTECTION EQUIPMENT
MAY BE NECESSARY WHEN USING CHEMICAL
SUBSTANCES.
Follow the instructions on the labels of the chemi-
cal substances and on the filters to be used.
20