LANDINI 5860, Руководство по эксплуатации и обслуживанию

Страница: 73 / 132

Maintenance
69
ROUTINE MAINTENANCE GUIDE
RUNNING-IN PERIOD
Constant efficiency and a long working life depend largely on how the tractor is treated during the running in period.
It is therefore extremely important to comply with these instructions:
•
your engine does not require any special running in when new. You can use it at full power from the start but
you must never overload. Avoid using the engine at full power before it reaches an operating temperature of at
least 60°C (140°F);
•
every time you start the engine from cold, let it run slowly without load for a few minutes to warm up. This is
particularly important with turbo-charged engines;
•
avoid idling the engine for long periods;
•
regularly check for oil leaks;
•
to ensure long clutch life, carefully run in the clutch plates. To do this, operate the clutch frequently but gradually
during the first 15 hours service.
The above precautions also apply if the engine has been overhauled or major components replaced.
After the first 50 hours
•
Change the engine oil and the engine oil filter cartridge (op. 27 and 28). Then change the engine oil (op. 28) and
diesel fuel (op. 33) filters twice at 100 hour intervals. After this, change the oil and diesel fuel filters at the
intervals specified in the “Routine Maintenance Guide”.
•
Hydraulic lift: thoroughly wash the gauze filter on the intake (op. 29).
•
Thoroughly wash the gauze filter for the power steering system (op. 32).
•
Make sure that the idle travel of the gearshift clutch pedal is 3.5-4 cm. (op. 13) and that of the PTO clutch lever 4-
5 cm. (op. 14). Adjust the idle travel if necessary.
•
Make sure that all screws, nuts and bolts are tight.
•
Check all oil levels and top up with the correct type if necessary.
•
Check the tension of the fan belt.
•
Grease all points provided with grease nipples.
•
Check tyre pressures.
PREPARING FOR LONG
IDLE PERIODS
•
Park the tractor in a dry, sheltered place.
•
Clean the tractor.
•
Drain the coolant from the radiator and cylinder block.
•
Grease all points provided with grease nipples.
•
Clean all diesel fuel and oil filters.
•
Drain the fuel tank and fill up with fresh diesel fuel.
•
Remove the injectors and squirt a small quantity of engine oil into the cylinders. Turn the engine over by hand
replace fit the injectors back in place.
•
Disconnect and remove the battery. Smear the terminals with clean Vaseline (not normal grease).
•
Recharge the battery every three months while the tractor is idle.