Kyoeisha Baroness LM531, Руководство по обслуживанию

Страница: 144 / 161

1 Wheel motor shaft
2 Wheel mount
3 Mount bracket
4 Caliper
Install the disc spring washer and slotted nut.
Install wheel mounting base bracket F of the
special tool.
3
1,2
b8kbof-010
Installation of Brake Caliper_007
1 Disc spring washer
2 Slotted nut
3 Wheel mounting base bracket F
Tighten the slotted nut with a torque wrench.
Note:
Tightening torque
180 - 200 N-m
(1,835.46 - 2,039.40 kgf-cm)
(1,593.18 - 1,770.20 lb-in)
If the hole of the cotter pin does not fit even
after tightening the slotted nut by the above-
mentioned tightening torque, tighten it more
until it fits into the hole.
When the hole fits, install the cotter pin into
the slotted nut.
1
b8kbof-011
Installation of Brake Caliper_008
1 Torque wrench
10.
11.
Adjust with the adjustment bolt until the pin
fits into the connections of the cam and
brake wire.
When the pin fits, connect the brake wire
and cam by using the pin, washer, and cotter
pin.
Adjust with the adjustment bolt until there is
no play between the cam and brake wire.
Follow the same steps to install the caliper
on the opposite side.
1
2
3
4
b8kbof-009
Installation of Brake Caliper_009
1 Brake wire
2 Cam
3 Pin, washer, cotter pin
4 Adjustment bolt
Install the front wheel.
Inspect whether the brake is activated
properly and then drive the machine.
12.
13.
14.
LM531
Main Vehicle
Page 6-12
Mechanical brake manual