Kyoeisha Baroness LM531, Руководство по обслуживанию

Страница: 141 / 161

Place the wheel mounting base (disc rotor
part) with the calipers attached.
As shown in the illustration, prepare two
double-folded corrugated cardboards in an
appropriate size
3
2 2
1
u5l8nd-007
Removal of Brake Caliper_007
1 Corrugated cardboard
2 Caliper
3 Wheel mounting base (disc rotor part)
Remove the front and rear calipers in order
from the disc rotor part.
After removing the caliper, insert the
corrugated cardboard prepared in Procedure
9 immediately between the cam pad and
carrier pad.
If the corrugated cardboard is not inserted,
the pads will be misaligned inside the
caliper, and it may be difficult to remove the
inner parts.
1
2
u5l8nd-008
Removal of Brake Caliper_008
1 Pad (cam)
2 Pad (carrier)
9.
10.
Place the caliper with the side where the disc
rotor is to be inserted oriented upward.
Remove the corrugated cardboard with
holding the pad by hands to prevent the cam
pad from getting out.
Pull out the carrier pad and pad support
upward through the groove of the housing.
3
4
2
1
u5l8nd-009
Removal of Brake Caliper_009
1 Housing
2 Pad (cam)
3 Pad (carrier)
4 Pad support (carrier)
Remove the cam pad, pad support, and
spring retainer through the hole on the
carrier housing.
Note:
The cam pad support is worn by the cam
pushing it.
Inspect the depth of the wear groove.
If the depth of the groove is deeper than 0.5
mm (0.02 in), replace the pad support.
1
4
3
2
u5l8nd-010
Removal of Brake Caliper_010
1 Housing
2 Pad (cam)
3 Pad support (cam)
4 Spring retainer
11.
12.
Main Vehicle
LM531
Main Vehicle
Page 6-9
Mechanical brake manual