Kyocera Ci1000, Руководство по эксплуатации

Страница: 127 / 214

6
6-27 Viewing and changing Setup from Fiery WebSetup
IP Address
—Enter the Ci1000 IP address for Token Ring. The Ci1000 is shipped
with the IP address set to the loopback address, (127.0.0.1) which is an internal
address used for network checking. If you plan to print with TCP/IP, you must
first assign the Ci1000 a unique network IP address. For information about
setting up printing with TCP/IP, see the Setup Manual or Operating Instructions.
Subnet Mask
—If you need to set the subnet mask, enter one of the following
values:
•
255.0.0.0
if the IP address starts with a number less than 128
• 255.255.0.0 if the IP address starts with a number from 128 through 191
•
255.255.255.0
if the IP address starts with a number greater than 191
Be sure to confirm the subnet mask setting with your network administrator
before proceeding. In some cases the required setting may be different from those
listed.
Gateway
—If your TCP/IP network has a gateway, and users outside the gateway
plan to print to the Ci1000 using TCP/IP, enter the gateway address here. By
default, the loopback address, 127.0.0.1, is set. Obtain the correct gateway address
from your network administrator.
Enable AppleTalk
—Enable this option if you have an AppleTalk network
connected to the Ci1000. This setting enables the Ci1000 to communicate over
AppleTalk networks.
Select Zone
— The Ci1000 searches the network for AppleTalk zones in your
network segment. Scroll through the list to select the AppleTalk zone in which
you want the Ci1000 to appear. If your segment has only one zone, the Ci1000 is
assigned to that zone automatically.
If no AppleTalk zone can be found, your network may have no defined zones, or
else the network cable has not been connected (see page 4-4). Choose OK.
Select Frames
—Click the Select Frames button to specify IPX frames used with
NetWare. See your network administrator to verify which frame type to choose.