Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 84 / 172

Glossary of Common Terms
KVAL Operation/Service Manual
2-54
Glossary of Common Terms
Item Description
Electrical Panels There are two electrical boxes, located near the back section
of the machine
Operator’s Station The operator’s station houses the 990FX touchscreen and
other operational control switches
Door Clamp
The door clamp secures the door to hold it in place as routing and drilling
occur.
Door Stop
The door stop sets the door in the correct position during in-feed.
Jamb Stop
The jamb stop acts as a jamb placement guide when jamb is being loaded
Door Clamp Pedal
The door clamp pedal is a foot pedal that, when pressed, activates the
door clamp to either clamp or unclamp the door.
Jamb Clamp Pedal
The jamb clamp pedal is a foot pedal that, when pressed, activates the
jamb clamps to clamp the jamb in place.
Routers Routers
are located in
on the lower front section to rout for
hinges, as well as a router on the back section to rout for the
faceplate
Six-Shooters The Six-Shooters are housed in the four movable heads on
the upper front section of the machine. The Six-Shooters
apply the screws to secure hinges to the door and jamb
Pre-drills The pre-drills are located in the Carriage Heads and pre-drill
the screw holes for hinge screw application.
Bolt Drill The bolt drill is located on the back section, and drills a hole
for the bolt.
Lock Bore The lock bore is located on the back section, and bores a hole
for the lock