Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 124 / 172

Replacing Bits
KVAL 990-FX Operation/Service Manual
4-34
6.
Tighten the collet assembly.
7.
Inspect and verify the work. Clean the work area.
8.
If maintenance is completed, replace dust cover and tighten bolts.
9.
Slide in the new chisels.
10.
Tighten bolts back and forth until the bracket is tight.
11.
Inspect and verify the work. Clean the work area.
12.
If maintenance is completed, replace dust cover and tighten bolts.
Remove and Replace the Screwdriver Bits
To replace screwdriver bits on the Six-Shooter heads, follow the instructions below.
1.
Turn off all power to the machine. Follow proper lockout/tagout procedures as
detailed in the safety section of Chapter 1 of this manual.
2.
Disconnect air from Six-Shooter using the air-connect slide valves. Slowly slide the
valves back toward you; listen for air to be released.
3.
Pull the Six-Shooter assembly toward the machine-it will move slightly.
4.
Locate the back slide near the air valves (see images); push slide away from you.
This allows for movement of the Six-Shooter assembly away from the machine.
5.
Move the Six-Shooter assembly away from the machine-it will move about 1½ inch.
This provides room for hands to access the screwdriver bit holders.