Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 93 / 172

Maintenance Schedule
4-3
KVAL 990-FX Operation/Service Manual
3,000 Cycles
Inspect Inspect feed belts for proper tension or damage.
Inspect Inspect screw drop tubes for kinks, cracks or wear from rubbing. Ensure tube
clamps are tight.
Inspect Inspect all photo eyes secure and tight.
Inspect
Inspect all limit switch arms for tightness or breaks
Inspect Inspect split shells and screw receivers on six shooters for cracks or breaks.
Replace if broken.
Inspect Inspect all airlines for kinks or rubbing.
Lubricate Refill all lubricators. Replace fluid if milky or discolored. Use ab ISO 32 stan-
dard hydraulic oil (KVAL PN:SYS-LUBEG).
Lubricate Grease ball screw bearings (if applicable).
Clean Clean all bearing shafts with clean, dry cloth.
12,000 Cycles
Inspect Inspect chains for proper tension or damage
Inspect Inspect all air cylinders for air leaks. Replace if seal is leaking
Inspect
Inspect hydraulic lines for loose fittings, leaks and cracks.
Inspect
Inspect ball rail shafts for pitting or abrasions.
Lubricate
Clean and lubricate all slides and cylinder rods with dry silicone spray
Lubricate
Lubricate all bearing shafts with silicone and clean rag.
Clean
Clean inside hopper with WD-40 and a 3M Scotchbrite
®
pad. Wipe dry with a
clean dry rag
72,000 Cycles
Inspect Inspect all nuts and bolts for tightnesses Tighten is necessary.
Inspect
Check that there is a smooth transition with a door feeding into and out of
machine.
Back-up
Backup computer software.
Clean
Wash filter and lubricator bowls with soapy water.