Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 80 / 172

About the Setup Screen
KVAL Operation/Service Manual
2-50
Adjusting Lock Location
1.
Select the size door ( 6'8''-7'0''-8'0'')
2.
Select Right Hand or Left Hand depending on
the door run through process.
3.
Under Base, select the
Combine with Base
but-
ton.
4.
Enter a positive number to move the lock cut to
the left. Enter a negative number to move the
lock cut to the right.
5.
Re-run the lock cut.
6.
Measure again and repeat steps 3 to 4 until the
center of the lock is at the desired cut location.
7.
Once the completed with calibration, select the
Combine with Base
button to store the data.
8.
Exit Main Calibration Screen.
Timing: Front Section and Back Section
Use the
Timing Controls
to tune the synchronization of
the
Carriage Head
routine and the
Face Plate
routine. If
Either process is finishing too soon or later than each
other, use the slide controls to match the timing.
Note: This is rarely used. In some cases severe climate
changes may cause some of the cylinders to become
sluggish.