Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 46 / 172

Tour of the Machine
KVAL Operation/Service Manual
2-16
The back section of the Hopper will cycle upward once to shift all the screws from
the back door to clear screws between the back door of the hopper and the slides.
9.
Once the Hopper is in the up position, the door will open and the Hopper will cycle
down quickly to throw the surplus of screws out the funnel container.
10.
Once in the back section is in the down position, the front section (
Screw Tracking
Assembly
) moves upward to drain the rest of the screws out of the hopper this will
cycle one more time to clear the screws from the slides.
11.
Press the
Reset
button on the Six Shooter panel located mid machine on the front
section.
12.
Fill the Hopper with new screws.
About the Six Shooter Assembly
Settings for the Six Shooter assemblies are entered in the User Interface. Door is automatically
positioned while the operator loads and clamps a hinge jamb. Routing and boring occur while the
operator places hinges into the nests of the hinge applicators. The Figures in this section illustrate
the
Six Shooter (Hoppers on Machine)
FIGURE 2-7.
Six Shooter Call-Outs Hoppers on machine
Horizontal Rails.
Allows the Six Shooter to
the move to the side for
Maintenance and Manual
application of Hinges
Vertical Rails:
Tubes:
Delivers Screws to Hinge
Applicator by way of plas-
tic tubes.
Driver Assembly:
Hinge Application:
Vertical Cylinder:
Drives Six Shooter Up
and Down
Spring: Tension for
vertical movement
Note: Air brakes are located on
the vertical rails. The brakes will
operate when air pressure goes
down a set reference level.