Kval 990FX, Руководство по эксплуатации и обслуживанию

Страница: 149 / 172

Valve Bank Locations
5-19
KVAL Operation/Service Manual
Typical Loads of Valve Banks
The table below lists the typical loads controlled by the valve banks.
Note: The values in this table are typical . Machine banks may be slightly different.To
verify, check the labels on the solenoids and the air schematic.
TABLE 5-2.
Valve Bank Loads (Cylinders)
Hopper 1-4(3) Extend and Retract:
• Hopper Up/Down,
• Pick Off Plate,
• Anti
Blow Back,
• Air Injection
Controls Hopper Functions. Located on
each Hopper.
In-Feed
Extend and Retract:
• Vert/Horz Index
• InFeed Door /Jamb Stop
• Jamb
Clamp
• Swing Clamp
• 1-4 (3) Drill Plunge
• 1-4 (3) Router Plunge
• Horizontal
• 1-1/4”
Vertical
• 1-7/8” Vertical
• 8” Vertical
Out-Feed Extend and Retract:
• #2 Router Plunge
• #2 Pre-Drill Plunge
• #4 Router Plunge
• #4 Pre-Drill Plunge
• Air to Pre-Drill #4
• Pre-Drill Blow Off
• #4 Swing Clamp
• 6’- 8’ Out-Feed Door Stops
• Out-Feed
Door/Jamb
• OPT- Split Jamb Stapler
Screw Driver 1-4(3) Extend and Retract:
• Head (A) Up/(B) Down
• Head in Position
• Head In and Locked
• Door Clamp
• Air Injection
• Air-E-Brake
Back section
Extend and Retract:
• Bolt Drill
• Face Plate Vertical
• Face Plate Tilt
• Self
Centering
• Face Bore
• Air to Edge Clamp
• Back
Sets
Ball Catch Option Extend and Retract:
• 7.0 Shift (Optional)
• Infeed Shift (Optional)
• Door Thickness
• InFeed Drill IN
• InFeed Drill Up and Down)
• Infeed
Shift (Optional)
• OutFeed Drill Up and Down)
• OutFeed Shift (Optional)
• 6-8’ to 8-0’ Shift