Installing the Tablet Monitor Controller (TMC)
Digital Eyewitness
®
HD
In-Car Video System
2–4
Manual Part Number:
006-1219-00 Rev. 0
10. Locate the ferrite clamp for the TMC. Open the ferrite clamp and align it with the TMC
cable, just slightly below the bottom edge of the TMC.
11. Make sure that the TMC cable is resting in the slot then close and lock the ferrite clamp.
Figure 2-5.
Ferrite Clamp Installation on Tablet Monitor Control Cable
12. Set the TMC assembly aside.
Tablet Monitor Controller Installation
The installer has some flexibility when installing the Eyewitness
®
HD system controller,
depending on the type of vehicle and the equipment in the vehicle.
IMPORTANT
Do not remove the protective film from the display until it is time
to hand the vehicle back to the customer. This will help protect
the display during installation.
Use the following criteria when determining where to install the display.
Airbag inflation zone
Officer safety
Line of sight
Critical vehicle controls
TMC Ball and Socket Mount
1.
Once the mounting position for the mount has been established, position the mount
base and mark the positions for the three (3) mounting screws.
2.
If possible, remove the panel that the mount will be attached to. This is done to prevent
damage to any wiring or other components behind the panel.
IMPORTANT
If it is not possible to remove the panel to drill the holes, prior to
drilling, make sure that any wiring or components that reside
behind the panel being drilled will not be damaged when drilling
the holes.
3.
Install the mount base to the panel using the supplied self-tapping screws.
4.
If the panel that the mount is being installed on was removed from the vehicle, reinstall
it at this time.
