Product Description
Digital Eyewitness
®
HD
In-Car Video System
1–6
Manual Part Number:
006-1219-00 Rev. 0
Power/Ground Connection Requirements
The following steps
MUST
be followed to ensure proper operation of the Digital Eyewitness
®
HD in-car video system.
1. A power tamer is included with the system and must be installed for the system to operate
properly . DO NOT substitute other models or manufacturers of similar devices. DO NOT
connect other equipment to the power tamer that is supplied with the Eyewitness
®
HD
system.
2. Main system power should be connected at the positive power lug at the main power
distribution block. If the main power distribution block does not have a positive power lug
available, the power lead may be connected to the positive post of the battery as a last
resort. On Ford Interceptor vehicles, a factory jumper harness is provided for these
connections.
3. Main system ground should be connected to chassis ground, as close to the negative
post of the battery as possible. On Ford Interceptor vehicles, a factory jumper harness is
provided for these connections.
IMPORTANT
Kustom Signals, Inc. strongly recommends against connecting
the ground lead directly to the negative post of the battery.
Kustom Signals, Inc. strongly recommends against cutting any
of the vehicle wiring.
Eyewitness
®
HD System Serial Numbers
Whenever service or technical assistance is required, contact a Kustom Signals’ customer
service representative by calling 1-800-835-0156 or 1-620-431-2700. The caller should be
prepared to provide the Serial Numbers for the system components requiring service.
The DVR serial number label is located on the rear panel of the DVR.
Figure 1-4.
Serial Number Location on the DVR
Model and
Serial Number
Location
