35
ASSEMBLY INSTRUCTIONS
6. Set the lock lever on the cable controller to the neutral
position.
A
Control lever should be neutral and be locked with lock
lever.
7. Install one lock nut to each cable end. Then route the
cable ends through the valve stay.
A
The cable with blue tape is for boom section and the
cable with red tape is for bucket section.
8. Install the other lock nuts to the cable ends and adjust
the location of lock nuts so that the cable end hole
aligns with the spool hole. Then connect the cable to
the spools with pins.
9. Loosen the M6 lock nuts of the cable ends. Turn the
cable ends and spools so that the direction of the pins
should be as shown in the figure. Then retighten the
M6 lock nuts.
A
To reposition the cables for correct connections, use
the M16 lock nuts.
(1) Lock lever
(A) "LOCK"
(B) "UNLOCK"
(1) Cable (Blue, Boom section)
(2) Cable (Red, Bucket section)
(3) 2-M16 Lock nuts
(4) Valve stay
(5) Spool (Boom section)
(6) Spool (Bucket section)
(1) Cable (Blue, Boom section)
(2) Cable (Red, Bucket section)
(3) Valve stay
(4) 2-M16 Lock nuts
(5) Spool (Boom section)
(6) Spool (Bucket section)
(7) 2-Pins
2-Snap pins
(1) 2-M6 Lock nuts
