KTM 950 ADVENTURE 2003, Руководство пользователя

Страница: 53 / 160

5-18
Repair manual KTM LC8
Art.-Nr
. 3.206.009-E
Checking the freewheel
– Insert the freewheel gear 1 in the freewheel.
– You should be able to turn the freewheel gear in a counterclockwise
direction.
– The freewheel gear should block without backlash in a clockwise
direction.
– Check the reduction gear 2 and the needle bearings 3 for wear,
replace if necessary.
Replacing the freewheel hub
– Remove the 6 bolts, tap the side of the freewheel hub with a plastic
hammer and remove the freewheel hub.
– Hold the components of the freewheel
4
together.
– Check the segments in the freewheel for wear.
– Check the freewheel hub
5
at the freewheel running surface for wear.
– Apply Loctite 648 to the flange areas on the rotor and the freewheel
hub.
– Mount the freewheel hub on the rotor.
– Apply Loctite 648 to the thread of the bolts and tighten the bolts
crosswise to 13 Nm.
! CAUTION !
A
LWAYS USE NEW BOLTS
(
QUALITY GRADE
12.9)
AND COAT BOLT THREAD WITH
L
OCTITE
648.
– Generously oil the freewheel and insert in the freewheel hub.
Starter
– Since the starter will show little wear after 10,000 starts and the
replacement of individual parts is uneconomical, these steps will not
be described in detail at this point.
– Replace the O-ring
6
on the starter flange.
1
2
3
3
5
4
6