Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 96 / 278

8 Operation
8.18 Removing crop blockages
96
Comprima F 155 XC
Original Operating Instructions 150001050_01_en
8.18.3 Crop blockage under the cutting rotor
RPG000-164
To remove the accumulated crops from under the cutting rotor (1), proceed as follows:
„
Switch off the PTO shaft.
„ Reverse.
„
Ensure that the tractor is in straight alignment with the machine.
„
To lift the pick-up, actuate the control unit on the tractor (yellow, 3+).
„ Switch on the PTO shaft and test at idling speed whether the crop blockage is being
removed.
If this does not remove the crop blockage:
For version with "Mechanical blade group control system"
„
Switch off the PTO shaft.
„ Hydraulically lower the blade cassette, refer to page 84 .
„
Shut down and safeguard the machine, refer to page 27 .
„ Manually swivel out the blade groups (setting A/B: -/-), refer to page 85 .
„
Switch on the PTO shaft and test at idling speed whether the crop blockage is being
removed.
For version with "Hydraulic blade group control system"
„
Switch off the PTO shaft.
„ To lower the blade cassette hydraulically, actuate the control unit on the tractor (green, 7-).
ð The blade cassette and the blade groups are lowered.
„
Switch on the PTO shaft and test at idling speed whether the crop blockage is being
removed.
If this does not remove the crop blockage:
„
Shut down and safeguard the machine, refer to page 27 .
CAUTION! Risk of injury due to sharp parts! Always wear appropriate protective gloves
when removing crop blockages.
„
Manually remove the accumulated crops.
When the crop blockage has been removed, put the cutting unit back into operation as follows: